Skip to content

Circuit simulator: Ohm's law, series and parallel

Build a simple circuit, change the battery and the resistors, and watch the current and voltages update. Then switch to test mode and work the answer out yourself. Free, no sign-up.

Battery and resistors

Test mode hides the readings and asks you to calculate one of them.

PartV (V)I (mA)P (mW)

The whole circuit on one graph

The line shows the current the battery would push through this circuit at each voltage. The dot is where you are now. A steeper line means a smaller total resistance.

Rules to remember

V = I × R    P = V × I = I²R
Series: R(total) = R1 + R2, same current everywhere
Parallel: 1/R(total) = 1/R1 + 1/R2, same voltage across each branch
  • In series the current is the same through every resistor and the voltages add up to the battery voltage.
  • In parallel the voltage across every branch equals the battery voltage and the branch currents add up.
  • Adding a resistor in series raises the total resistance. Adding one in parallel lowers it, always below the smallest branch.
  • Try it: set both resistors to the same value in parallel. The total is exactly half.
  • Check by adding up: in test mode, work out all the voltages first, then check they add to the battery voltage.

A teaching model with an ideal battery, ideal wires and a perfect ammeter, and resistors whose resistance stays the same as they heat up. Currents are shown in milliamps (mA); 1000 mA = 1 A. Ask Alex to quiz you once you have had a go.

Ask Alex about circuits, free

Alex opens already knowing what you just tried. 10 free messages with Alex. Built for ADHD and dyslexic learners as well as everyone else.